Akemi PEARL Impregnator Quartzite Sealer

This product is offered in the following options — select your choice above:

• Very fast development of the protective effect with an outstanding pearl (beading) effect
• Low color enhancement — ideal for light-colored marble and limestone
• Very good oil- and grease-repellent effect; strong reduction of water and dirt absorption in humid conditions
• High vapor permeability — the surface breathes because no surface layer is formed
• Anti-graffiti effect from the low adhesion of paints on treated surfaces
• Non-yellowing and resistant to UV radiation; tack-free hardening
• High coverage — up to 350 ft² (35 m²) per liter — with no methanol released during curing

For water-, grease- and oil-repellent treatment of mineral building materials, including:

• Marble, limestone, granite, gneiss, porphyry and sandstone (polished, ground or rough)
• Quartz, terrazzo, cotto and fine stoneware — especially suited to light-colored marble and limestone
• Concrete, cement tiles and unglazed ceramic tiles
• Floors, kitchen coatings, bathrooms, wash tables, tables, window sills and facades (anti-graffiti)

Not suitable for: glazed and non-absorbent surfaces, or plaster.

1. The surface must be clean, completely dry and free of all layers. After any cleaning, allow the stone to dry — usually 1–2 days at the earliest.
2. Prepare a 1–2 m² sample area to check efficiency, appearance (color enhancement) and material consumption.
3. Shake well before use. Best conditions are 50–86°F (10–30°C), with protection from moisture for about 2–3 hours. Do not warm the stone with underfloor heating or direct sunlight.
4. Apply with a brush or mop. Generally one to two coats wet-in-wet are sufficient. Apply so the product does not run down.
5. About 20 minutes after application — before the impregnation dries on the surface — wipe off any excess that has not been absorbed with a suitable cloth. Polished surfaces should be polished again until any blooming is removed.
6. If needed, apply once more. The water-repellent effect develops after a few minutes; full protection after 2–3 hours.
7. Clean tools with AKEMI® Nitro Thinner. When used in food areas, ventilate for approximately 2–3 days.

• For professional use only. Disregarding the processing guidelines can lead to irreparable damage.
• A surplus of product causes blooming and spotting — always remove excess before it dries.
• In spray application, avoid forming aerosols; do not breathe vapors (wear a protective mask).
• Protect surrounding solvent-sensitive materials (window screens, parts to be varnished, cars, plants) from contact.
• On some dark stones (e.g. Nero Assoluto, Nero Impala) the stone’s own structures may intensify in color — this is a characteristic of the stone, not a product defect.
• Re-apply about once a year on heavily used surfaces such as floors.
• Industrial chemical product — use only in well-ventilated areas and wear chemical-resistant gloves and eye protection. Always consult the AKEMI Safety Data Sheet (SDS) before use.

• 📄 AKEMI Stone Care Product Portal — Technical Data Sheet & SDS (manufacturer)