$ 3.15
$ 3.15
$ 3.15
-
Brand
| Brand: Akemi |
Akemi Mixing Nozzle — Dental Tip for 1:1 50 mL Cartridges
This static mixing nozzle is the disposable applicator tip for AKEMI® two-component adhesives supplied in 1:1, 50 mL twin cartridges. As the two components are pushed through the nozzle’s internal helix they are blended to a uniform, ready-to-use mix, while the fine, tapered “dental” tip places the adhesive precisely into narrow joints, chips, and hairline repairs. Fit a fresh nozzle for each fill so the mix ratio and cure stay reliable.
- Thorough static mixing — blends both components as they dispense
- Fine dental tip — precise placement in tight joints and chips
- For 1:1, 50 mL twin cartridges of AKEMI two-component adhesive
- Single-use consumable — swap a fresh nozzle per fill
| Property | Detail |
|---|---|
| Brand | Akemi |
| Type | Static mixing nozzle with fine dental tip |
| Fits | AKEMI® 1:1 50 mL twin cartridges |
| Function | Blends both components on dispensing for a ready-to-use mix |
| Use | Single-use consumable |
| Manufacturer Part Number | MISC.14031 |
- Internal helix mixes resin and hardener evenly as the cartridge is dispensed
- Fine, tapered dental tip for accurate placement in narrow joints, chips, and cracks
- Eliminates hand-mixing for consistent, bubble-free results on small repairs
- Matched to AKEMI® 1:1, 50 mL twin-cartridge adhesives
- Load the 50 mL twin cartridge into the matching dispensing gun.
- Before fitting the nozzle, dispense a small amount to level both pistons so the components start evenly.
- Push a fresh mixing nozzle onto the cartridge outlet and secure it.
- Dispense; the adhesive emerges pre-mixed and ready to place through the dental tip.
- Leave the used nozzle in place to cap the cartridge between uses, and fit a new nozzle for the next application.
- Observe the safety guidance and Safety Data Sheet for the adhesive being dispensed.
- Work in a well-ventilated area and wear chemical-resistant gloves and eye protection when handling adhesives.
Accessory item. Follow the safety instructions and Safety Data Sheet of the two-component adhesive used with this nozzle. Work in a well-ventilated area and wear chemical-resistant gloves and eye protection.